Avaya 4526FX - Selecting the ACLI Banner Type Using EDM

6. Type the desired value in the Asset ID field.
7. On the toolbar, click Apply.
Variable definitions
The following table is an example for a stack of 2 units and you can extend this up to 8 units.
Use the data in the following table to complete this procedure.
Variable Value
Stack Sets the Asset ID of the stack
Unit 1 Sets the Asset ID of unit 1 in the stack
Unit 2 Sets the Asset ID of unit 2 in the stack
Selecting the ACLI banner type using EDM
Use this procedure to select type of banner that is displayed in the
A
vaya Command Line
(ACLI) Telnet screen.
Procedure steps
1. From the navigation tree, double-click Edit
.
2. In the Edit tree, double-click Chassis.
3. In the Chassis tree, double-click Chassis.
4. On the work area, click the Banner tab.
5. In the BannerControl section, click a radio button.
6. Click Apply.
Variable definitions
Use the information in the following table to select the ACLI banner type.
System configuration using Enterprise Device Manager
224
Configuration — System April 2011