Procedure steps
1. From the navigation tree, double-click Edit
.
2. In the Edit tree, double-click File System.
3. On the work area, click the ASCII Config Script Files tab.
4. In the table, double-click the cell under the ScriptSource heading for the parameter
you want to change.
5. Type the IP address of the desired TFTP server and the name under which to store
the configuration file in the format— tftp://<ip address>/<filename>.
If you retrieve the configuration file from a USB storage device, and the USB is
inserted in a stand-alone unit, type the name under which to store the configuration
file in the following format—usb://<filename>.
If the USB device is inserted in a unit of a stack, type usb://<unit number>/
<filename>.
6. Double-click the cell under the ScriptManual header, and select Download option
to transfer the file from a TFTP server or from a USB mass storage device.
7. On the toolbar, click Apply.
8. Check the ScriptLastStatusChange field for the file transfer status.
If the status of the file download is manualDownloadInProgress, wait for up to 2
minutes, and then click Refresh to see any new status applied to the upload.
The file downlaod is complete when the status displays either
manualDownloadPassed or manualDownloadFailed.
Automatically downloading a configuration file using EDM
Use the following procedure to download a configuration file automatically.
Important:
When you use the TFTP
address parameter to perform copy or download commands, the
system overwrites the TFTP server address
ASCII configuration file management using EDM
Configuration — System April 2011 245
To Next Page
Loading...
