Parameters and
variables
Description
• static
• custom
banner command
The banner command specifies the banner that is displayed at startup; either static or
custom.
The syntax for the banner command is:
banner {static | custom} <line number> "<LINE>"<disabled>
The following table describes the parameters for this command.
T
able 38: banner parameters
Parameters and
variables
Description
static | custom Set the display banner as
• static
•
custom
line number Enter the banner line number you are setting. The range is 1–
19.
LINE Specify the characters in the line number.
disabled Disable the banner display.
Run the banner command in Global Configuration command mode.
no banner command
The no banner command clears all lines of a previously stored custom banner.
This
command sets the banner type to the default setting (STATIC).
The syntax for the no banner command is
no banner
Run the no banner command in Global Configuration command mode.
System configuration using ACLI
104 Configuration — System April 2011
To Next Page
Loading...
