Variable Value
DetectionStatus Displays the operational status of the power-device detecting mode on
the specified port:
• disabled—detecting function disabled
•
searching—detecting function is enabled and the system is searching
for a valid powered device on this port
• deliveringPower—detection found a valid powered device and the port
is delivering power
• fault—power-specific fault detected on port
• test—detecting device in test mode
• otherFault
Important:
Avaya recommends against using the test operational status.
PowerClassifica
tions
Classification is a way to tag different terminals on the Power over LAN
network according to their power consumption. Devices such as IP
telephones, WLAN access points, and others can be classified according
to their power requirements.
PowerPriority Lets you set the power priority for the specified port to:
• critical
• high
• low
PowerLimit(watt
s)
Specifies the maximum power that the switch can supply to a port. The
default value is 16W.
Voltage(volts) Indicates the voltage measured in Volts.
Current(amps) Indicates the current measured in amps.
Power(watts) Indicates the power measured in watts.
Configuring PoE for switch or stack ports using EDM
Use this procedure to modify the PoE configuration for a one or more switch or stack ports.
Procedure steps
1.
From the navigation tree, double-click Power Management
.
2. In the Power Management tree, double-click PoE.
PoE configuration for switch ports using EDM
Configuration — System April 2011 237
To Next Page
Loading...
