This feature is enabled by default. There are no configuration commands for this feature.
Displaying unit uptime
Y
ou
can display the uptime for each unit in a stack. Unit stack uptime collects the stack uptime
for each unit in a stack and reports this information when requested. You can determine how
long each unit is connected to the stack. You can use ACLI commands to display the unit
uptimes.
Port naming
You can name or specify a text string for each port.
This feature provides easy identification
of the connected users.
Use ACLI or EDM to name ports.
Port error summary
You can view all ports that have errors in an entire stack.
If a particular port has no errors, it is not displayed in the port error summary
.
IP address for each unit in a stack
You
can assign an IP address to each unit in a stack. Use ACLI to configure the IP addresses
for each unit within a stack.
BootP mode
The A
vaya Ethernet Routing Switch 4500 Series supports the Bootstrap protocol (BootP).
You can use BootP to retrieve an ASCII configuration file name and configuration server
address.
System configuration fundamentals
52 Configuration — System April 2011
To Next Page
Loading...
