Variables Description
med
The Media Endpoint Device (MED) for a specific
TLV
.
lldp tx-tlv dot1 command
The lldp tx-tlv dot1 command sets the optional IEEE 802.1 organizationally-specifc
TLVs to be included in the transmitted LLDPDUs.
The syntax for the lldp tx-tlv dot1
command is
(config)#lldp tx-tlv [port <portlist>] dot1 [port-protocol-vlan-id
<vlanlist>] [port-vlan-id ] [protocol-identity < [EAP] [LLDP] [STP]>]
[vlan-name <vlanlist>]
The lldp tx-tlv dot1 command is in the Interface Configuration command mode.
The following table describes the variables for the lldp tx-tlv dot1 command.
Table 78: lldp tx-tlv dot1 command variables
Variables Description
port <portlist> The ports affected by the command.
port-protocol-vlan-id <vlanlist> The port and protocol VLAN ID TLV.
port-vlan-id The port VLAN ID TLV.
protocol-identity <[EAP] [LLDP]
[STP]>
Protocol Identity TLV
vlan-name <vlanlist> The VLAN name TLV.
lldp tx-tlv dot3 command
The lldp tx-tlv dot3 command sets the optional IEEE 802.3 organizationally-specifc
TLVs to be included in the transmitted LLDPDUs.
The syntax for the lldp tx-tlv dot3
command is
(config-if)#lldp tx-tlv [port <portlist>] dot3 [link-aggregation]
[mac-phy-config-status] [maximum-frame-size][mdi-power-support]
Run the lldp tx-tlv dot3 command in Interface Configuration command mode.
The following table describes the variables for the lldp tx-tlv dot3 command.
System configuration using ACLI
168 Configuration — System April 2011
To Next Page
Loading...
