Variable Value
Status Specifies whether Avaya topology is on (topOn) or off (topOff) for the
device. The default value is topOn.
NmmLstChg
Indicates the value of sysUpTime the last time an entry in the network
management MIB (NMM) topology table was added, deleted, or modified.
If the table has not changed since the last cold or warm start of the
agent.
NmmMaxNum Indicates the maximum number of entries in the NMM topology table.
NmmCurNum Indicates the current number of entries in the NMM topology table.
Viewing the topology table using EDM
Use this procedure to display the topology table.
Procedure steps
1. From the navigation tree, double-click Edit.
2.
In the Edit tree, double-click Diagnostics.
3. In the Diagnostics tree, double-click Topology.
4. In the work area, click the Topology Table tab.
Variable definitions
Use the data in this table to help you understand the topology table display.
Variable Value
Slot Indicates the slot number in the chassis in which the topology message
was received.
Port Indicates the port on which the topology message was received.
IpAddr Indicates the IP address of the sender of the topology message.
SegId Indicates the segment identifier of the segment from which the remote
agent sent the topology message. This value is extracted from the
message.
MacAddr
Indicates the MAC address of the sender of the topology message.
Viewing the topology table using EDM
Configuration — System April 2011 283
To Next Page
Loading...
