Prerequisites
Log on to the Privileged EXEC mode in ACLI.
Procedure steps
Display the received IP address configuration information for one or more switch ports
by using the following command:
show lldp [port <portlist>] neighbor vendor-specific avaya
phone-ip
Variable definitions
Variable Value
<portlist> Specifies a port or list of ports.
LLDP configuration example
By default,
LLDP is enabled for Tx and Rx on all switch ports. The default value for the LLDP
Tx interval is 30 seconds (LLDPDUs are sent at 30 seconds). With the default settings, only
the mandatory TLVs are sent, but the switch can receive any LLDP Core, DOT1, DOT3 TLV,
or Med-capabilities TLV from its peers.
The following figure shows an example of LLDP configuration. For this example, the router is
connected to the Avaya Ethernet Routing Switch 4500 Series port 1 and the IP Phone uses
port 13
System configuration using ACLI
192 Configuration — System April 2011
To Next Page
Loading...
