Variable definitions
Use the data in this table to help you configure IPv6 globally.
Variable Value
AdminEnabled Enables or disables administration function.
OperEnabled Enables or disables the operation.
Forwarding Indicates whether this acts as a router or not.
DefaultHopLimit Indicates the Hop Limit. Default number of hops— 30
IcmpNetUnreach Enables or disables the ICMP net unreach feature.
IcmpRedirectMsg Enables or disables ICMP redirect message feature.
IcmpErrorInterval Indicates the time to wait before sending an ICMP error
message. A
value of 0 means the system does not send an
ICMP error message. Range is 0–2147483647 ms.
IcmpErrorQuota Indicates the number of ICMP error messages that can be sent
out during ICMP error interval. Default value: 1
MulticastAdminStatus Indicates the admin status for multicast for this interface.
IPv6 interface management using EDM
Use the information in this section to view, create, or delete IPv6 interfaces.
Viewing IPv6 interfaces using EDM
Use the following procedure to view an IPv6 interface ID to a VLAN to learn the ID.
Procedure steps
1. From the navigation tree, double-click IPv6
.
2. In the IPv6 tree, double-click IPv6.
3. On the work area, click the Interfaces tab.
System configuration using Enterprise Device Manager
250 Configuration — System April 2011
To Next Page
Loading...
