Avaya 4526FX - Viewing LLDP Neighbor Link Aggregation Information Using EDM

Variable Value
PowerMDISupported Indicates whether MDI power is supported on the
remote port.
PowerMDIEnabled Indicates whether MDI power is enabled on the remote
port.
PowerPairControlable Indicates the value derived from the value of the
pethPsePortPowerPairsControlAbility object (defined
in IETF RFC 3621), this value is used to indicate
whether pair
selection can be controlled on the remote
port.
PowerPairs Contains the value of the pethPsePortPowerPairs
object (defined in IETF RFC 3621) for the remote
port.
• signal
•
spare
PowerClass Contains the value of the
pethPsePortPowerClassifications object (defined in
IETF RFC 3621) for the remote port.
• class0
•
class1
• class2
• class3
• class4
Viewing LLDP neighbor link aggregation information using EDM
Use the following procedure to display LLDP link aggregation properties for the remote
system.
Procedure steps
1.
From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click Port dot3.
5. On the work area, click the Neighbor Link Aggregate tab.
System configuration using Enterprise Device Manager
314 Configuration — System April 2011