Variable Value
PortNum Indicates the port number.
ProtocolIndex Indicates the arbitrary local integer value used by this
agent to identify a particular protocol identity.
ProtocolId Indicates the octet string value used to identify the
protocols associated with the given port of the local
system.
ProtocolTxEnable Specifies whether the corresponding Local System
Protocol Identity instance is transmitted on the port.
Viewing LLDP neighbor VLAN ID information using EDM
Use the following procedure to view the LLDP VLAN ID properties for the remote system.
Procedure steps
1.
From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click Port dot1.
5. On the work area, click the Neighbor VLAN Id tab.
Variable definitions
The following table describes the Neighbor VLAN ID tab fields.
Variable Value
TimeMark Indicates the TimeFilter for this entry.
LocalPortNum Identifies the local port on which the remote system
information is received.
Index Indicates the arbitrary local integer value used by this
agent to identify a particular MSAP.
An agent is
encouraged to assign monotonically increasing index
values to new entries, starting with one, after each
reboot.
VlanId Indicates the port VLAN identifier associated with the
remote system. If the remote system does not know
LLDP Port dot1 configuration using EDM
Configuration — System April 2011 305
To Next Page
Loading...
