restore factory-default [-y]
the [-y] parameter instructs the switch not to prompt for confirmation.
Configuring IPv6
Use the following procedures to configure IPv6:
• Enabling IPv6 interface on the management VLAN on page 1
14
•
Configuring IPv6 interface on the management VLAN on page 1
15
•
Displaying the IPv6 interface information on page 115
• Displaying IPv6 interface addresses on page 116
• Configuring an IPv6 address for a switch or stack on page 117
• Displaying the IPv6 address for a switch or stack on page 118
• Configuring IPv6 interface properties on page 118
• Disabling IPv6 interface on page 120
• Displaying the global IPv6 configuration on page 120
• Configuring an IPv6 default gateway for the switch or stack on page 121
• Displaying the IPv6 default gateway on page 121
• Configuring the IPv6 neighbor cache on page 121
• Displaying the IPv6 neighbor information on page 122
• Displaying IPv6 interface ICMP statistics on page 122
• Displaying IPv6 interface statistics on page 123
• Displaying IPv6 TCP statistics on page 124
• Displaying IPv6 TCP listeners on page 125
• Displaying IPv6 UDP statistics and endpoints on page 125
Y
ou can only execute ACLI commands for IPv6 interface configuration on the base unit of a
stack. Use the Global Configuration mode to execute IPv6 commands.
Enabling IPv6 interface on the management VLAN
Use the following procedure to enable an IPv6 interface to the management VLAN:
System configuration using ACLI
114 Configuration — System April 2011
To Next Page
Loading...
