Run the no ip bootp server command in Global Configuration command mode.
default ip bootp server command
The default ip bootp server command uses BootP when needed.
The syntax for the default ip bootp server command is:
default ip bootp server
Run the default ip bootp server command in Global Configuration command mode.
Customizing ACLI banner
You
can configure the banner that is presented when a user logs in to the switch through ACLI
to a user-defined value. The banner cannot exceed 1539 bytes, or 19 rows by 80 columns plus
line termination characters.
The banner control setting is saved to NVRAM, and both the banner file and control setting
are distributed to all units within a stack.
To customize ACLI banner using ACLI, see the following commands:
•
show banner command on page 103
• banner command on page 104
• no banner command on page 104
show banner command
The show banner command displays the banner.
The syntax for the show banner command is:
show banner [static | custom]
Run the show banner command in Privileged EXEC command mode.
The following table describes the parameters for the show banner command.
Table 37: show banner parameters
Parameters and
variables
Description
static | custom Specify which banner is currently set to be displayed:
Customizing ACLI banner
Configuration — System April 2011 103
To Next Page
Loading...
