Variable definitions
The following table defines optional parameters that you can enter after the show tdr test
command.
Variable Value
<WORD> Specifies a port or list of ports.
Enabling Autotopology
Use ACLI to configure the Enterprise
Autotopology protocol.
For more information about Autotopology, see
http://www.avaya.com. (The product family for
Enterprise and Autotopology is Data and Internet.)
T
o enable autotopology using ACLI, see the following sections:
•
autotopology command on page 144
• no autotopology command on page 144
• default autotopology command on page 145
• show autotopology settings command on page 145
• show autotopology nmm-table command on page 145
autotopology command
The
autotopology command enables the Autotopology protocol.
The syntax for the autotopology command is
autotopology
Run the autotopology command in Global Configuration command mode.
no autotopology command
The no autotopology command disables the Autotopology protocol.
The syntax for the no autotopology command is
no autotopology
Run the no autotopology command in Global Configuration command mode.
System configuration using ACLI
144 Configuration — System April 2011
To Next Page
Loading...
