10. Enable the Protocol Identity TLV for transmission. (indicates the supported
protocols by the LLDP sending port)
11. Enable the MAC/PHY Configuration/Status TLV for transmission. (indicates the
IEEE 802.3 duplex and bitrate capabilities and settings of the LLDP sending port)
12. Enable the Power Via MDI TLV for transmission. (indicates the MDI power support
capabilities of the LLDP sending port)
13. Enable the Link Aggregation TLV for transmission. (indicates the link aggregation
capability and status of the LLDP sending port)
14. Enable the Maximum Frame Size TLV for transmission. (indicates the maximum
frame size that can be handled by the LLDP sending port)
15. Enable the Location Identification TLV for transmission. (indicates the physical
location of the LLDP sending port; three coordinate sets are available to configure
and send)
16. Enable the Extended Power-via-MDI TLV for transmission. (provides detailed
informations regarding the PoE parameters of the LLDP sending device)
17. Enable the Inventory – Hardware Revision TLV for transmission. (indicates the
hardware revision of the LLDP sending device)
18. Enable the Inventory – Firmware Revision TLV for transmission. (indicates the
firmware revision of the LLDP sending device)
19. Enable the Inventory – Software Revision TLV for transmission. (indicates the
software revision of the LLDP sending device)
20. Enable the Inventory – Serial Number TLV for transmission. (indicates the serial
number of the LLDP sending device)
21. Enable the Inventory – Manufacturer Name TLV for transmission. (indicates the
manufacturer name of the LLDP sending device)
22. Enable the Inventory – Model Name TLV for transmission. (indicates the model
name of the LLDP sending device)
23. Configure the location information for the LLDP-MED Location Identification TLV.
(There are three coordinate sets available for location advertisement.)
24. Enable the LLDP-MED Capabilities TLV for transmission (indicates the supported
LLDP-MED TLVs and the LLDP-MED device type of the LLDP sending device)
Detailed configuration commands
The following section describes the detailed ACLI commands required to carry out the
configuration depicted by
Figure 13: LLDP configuration example on page 193
System configuration using ACLI
194 Configuration — System April 2011
To Next Page
Loading...
