ACLI Help
To obtain help on the navigation and use of the Command Line Interface (ACLI), use the
following command:
help {commands | modes}
Use help commands
to obtain information about the commands available in ACLI organized
by command mode. A short explanation of each command is also included.
Use help modes to obtain information about the command modes available and ACLI
commands used to access them.
These commands are available in any command mode.
Configuring AUR
This section describes ACLI commands used in AUR configuration.
show stack auto-unit-replacement command
The show stack auto-unit-replacement command displays the current AUR
settings.
The syntax for this command is
show stack auto-unit-replacement
The
show stack auto-unit replacement command is in all command modes.
No parameters or variables are available for the show stack auto-unit replacement
command.
stack auto-unit-replacement enable command
The stack auto-unit-replacement enable command enables
AUR on the switch.
The syntax for this command is
stack auto-unit-replacement enable
ACLI Help
Configuration — System April 201
1 105
To Next Page
Loading...
