The syntax for the ip address unit command is
ip address unit <1-8> [A.B.C.D]
Run the ip address unit command in Global Configuration command mode.
The following table describes the parameters this command.
Table 54: ip address unit parameters
Parameters and
variables
Description
unit <1—8> Sets the unit you are assigning an IP address.
A.B.C.D Enter IP address in dotted-decimal notation.
Important:
When the IP address or subnet mask changes, connectivity to
Telnet and the Internet can
be lost.
no ip address unit command
The no ip address unit command sets the IP address for the specified unit in a stack to
zeros (0).
The syntax for the no ip address unit command is
no ip address unit <1-8>
Run the no ip address unit command in Global Configuration command mode.
The following table describes the parameters this command.
Table 55: no ip address parameters
Variable Value
unit <1—8> Zeroes out the IP address for the specified unit.
Important:
When you change the IP address or subnet mask, connectivity to
Telnet and the Internet
can be lost.
Displaying Interfaces
You can view the status of all interfaces on the switch or stack, including MultiLink T
runk
membership, link status, autonegotiation, and speed.
System configuration using ACLI
138 Configuration — System April 2011
To Next Page
Loading...
