Job aid
Use the following commands to view the configured Asset ID.
•
show system
•
show sys-info
•
show tech
•
show system verbose
Disabling asset ID string
Perform this procedure to disable the asset ID string.
Prerequisites
Log on to the Global configuration mode in ACLI.
Procedure steps
1.
To disable the asset ID string enter the following command:
no asset-id [ stack | unit <1-8> | <cr> ]
2. To verify the asset ID string settings enter the following command:
show system
Variable definitions
Use the data in the following table to complete this procedure.
Variable Value
Stack Sets the Asset ID of the stack
Unit <1-8> Sets the Asset ID for specified unit in the
stack. Unit number: 1–8
Asset ID string configuration using ACLI
Configuration — System April 2011 199
To Next Page
Loading...
