default lldp command
The default lldp
command sets the LLDP transmission parameters to their default values.
The syntax for the default lldp command is
default lldp [tx-interval ] [tx-hold-multiplier ] [reinit-delay] [tx-
delay] [notification-interval] [med-fast-start]
If no parameters are specified, the default lldp sets all parameters to their default
parameters.
Run the default lldp command in Global Configuration command mode.
The following table describes the variables for the default lldp command.
Table 81: default lldp command variables
Variables Description
tx-interval Set the retransmit interval to the default value (30).
tx-hold-multiplier
Set the transmission multiplier to the default value
(4).
reinit-delay Set the reinitialize delay to the default value (2).
tx-delay Set the transmission delay to the default value (2).
notification-interval Set the notification interval to the default value (5).
med-fast-start
Set the MED fast start repeat count to the default
value.
default lldp port command
The default lldp port command sets the port parameters to their default values.
The
syntax for the
default lldp port command is
default lldp port <portlist> [config notification] [status]
Run the default lldp port command in Interface Configuration command mode.
The following table describes the variables for the default lldp port command.
Table 82: default lldp port command variables
Variables Description
port <portlist> The ports affected by the command.
System configuration using ACLI
170 Configuration — System April 2011
To Next Page
Loading...
