Table 88: no lldp med-network-policies command variables
Variable Value
port <portlist>
Specifies the port or ports on which to disable LLDP
MED policies.
voice Specifies the voice network policy to disable.
voice-signaling
Specifies the voice signalling network policy to
disable.
no lldp tx-tlv command
The no lldp tx-tlv command specifies the optional Management TL
Vs not to include in
the transmitted LLDPDUs. The syntax for the no lldp tx-tlv command is
no lldp tx-tlv [port <portlist>] [port-desc] [sys-name] [sys-desc]
[sys-cap] [local-mgmt-addr]
Run the no lldp tx-tlv command in Interface Configuration command mode.
The following table describes the variables for the no lldp tx-tlv command.
Table 89: default lldp tx-tlv command variables
Variables Description
port <portlist> The ports affected by the command.
port-desc
The port description TLV. This TLV is enabled by
default.
sys-name
The system name TLV. This TLV is enabled by
default.
sys-desc
The system description TLV. This TLV is enabled by
default.
sys-cap
The system capabilities TLV (default value is false: not
included).
local-mgmt-addr
The local management address TLV. This TLV is
enabled by default.
no lldp tx-tlv dot1 command
The no lldp
tx-tlv dot1 command specifies the optional IEEE 802.1 TLVs not to include
in the transmitted LLDPDUs. The syntax for the no lldp tx-tlv dot1 command is
Configuring LLDP using ACLI
Configuration — System April 2011 175
To Next Page
Loading...
