Variable Value
If an upgrade does not allow autonegotiation to correctly identify
the link
speed and duplex settings, you can manually configure
the settings for the link in question.
AdminDuplex The current administrative duplex mode of the port (half or full).
OperDuplex The current mode of the port (half duplex or full duplex).
AdminSpeed Set the port speed.
OperSpeed The current operating speed of the port.
AutoNegotiationCapab
ility
Specifies the port speed and duplex capabilities that a switch can
support on a port, and that can be advertised by the port using
auto-negotiation.
AutoNegotiation
Advertisments
Specifies the port speed and duplex abilities to be advertised
during link negotiation.
MltId The MultiLink Trunk to which the port is assigned (if any).
IsPortShared Specifies whether a port is shared. Multiple ports that are logically
represented as a single port are shared. Only one shared port can
be active at a time.
PortActiveComponent Specifies the physical port components that are active for a shared
port.
PoE configuration for switch ports using EDM
Use the information in this section to display and modify PoE configurations for switch ports.
Important:
The procedures in this section apply only to a switch with PoE ports.
Viewing PoE information for specific switch ports using EDM
Use this procedure to display the PoE configuration for specific switch ports.
Procedure steps
1. From the Device Physical V
iew, select one or more ports.
2. From the navigation tree, double-click Edit.
3. In the Edit tree, double-click Chassis.
System configuration using Enterprise Device Manager
234 Configuration — System April 2011
To Next Page
Loading...
