Set power limit for channels
The poe-limit command sets the power limit for channels.
The syntax for the poe-limit command is
poe poe-limit [port <portlist>] <3-16>
Table 45: poe-limit parameters on page 127 outlines the parameters for this command.
Table 45: poe-limit parameters
Parameter Description
port <portlist> The ports to set the limit on
<3 - 16> The power range to limit at from 3 to 16 W
Run the poe-limit command in Interface Configuration command mode.
Set traps control
The poe-trap command enables PoE-related traps for PoE-enabled ports.
The syntax for the poe-trap command is
poe poe-trap [unit <1-8>]
Substitute <1-8> with the number of the unit on which to enable traps.
Show main power status
The show poe-main-configuration command displays the power configuration.
The syntax for the show poe-main-configuration command is
show poe-main-status [unit <1-8>]
Substitute <1-8> with the number of the unit for which to display the configuration.
Run the show poe-main-status command in Privileged EXEC command mode.
Configuring PoE using ACLI
Configuration — System April 2011 127
To Next Page
Loading...
