Avaya 4526FX - Domain Name Server (DNS) Configuration

Parameter Description
count <1–9999> | continuous Set the number of ICMP packets to be sent. The
continuous mode sets the ping running until the user
interrupts it by entering Ctrl+C.
timeout | -t | <1–120> Set the timeout using either the timeout with the -t
parameter followed by the number of seconds the
switch must wait before timing out.
interval <1–60> Specify the number of seconds between transmitted
packets.
debug Provide additional output information such as the
ICMP sequence number and the trip time.
telnet command
Use the telnet
command to establish communications with another switch during the current
ACLI session. Communication can be established to only one external switch at a time using
the telnet command.
The syntax for this command is
telnet <ipv6_address | dns_host_name>
Substitute <ipv6_address | dns_host_name> with either the IPv6 address or the DNS
host name of the unit with which to communicate.
Run this command in User EXEC command mode.
Domain Name Server (DNS) Configuration
Use domain name servers when the switch needs to resolve a domain name (such as
avaya.com) to an IP address. Use the following commands to configure the switch domain
name servers:
• show ip dns command on page 161
• ip domain-name command on page 161
• no ip domain-name command on page 161
• default ip domain-name command on page 161
•
ip name-server command on page
162
•
no ip name-server command on page
162
System configuration using
ACLI
160 Configuration — System April 2011