9. Double-click the cell under the ScriptManual header, and select Upload option to
transfer the file to a TFTP server or to a USB mass storage device.
10. On the toolbar, click Apply.
11. Check the ScriptLastStatusChange field for the file transfer status.
If the status of the file upload is manualUploadInProgress, wait for up to 2 minutes,
and then click Refresh to see any new status applied to the upload.
The file upload is complete when the status displays either manualUploadPassed
or manualUploadFailed.
12. Click Apply .
Variable definitions
Use the information in the following table to help you to store the current ASCII switch
configuration file.
Variable Value
ScriptIndex Specifies the unique identifier for ASCII switch configuration
file.
ScriptBootPriority Specifies the boot priority of the ASCII switch configuration file.
Value ranges from 0–127.
ScriptSource Specifies the address where to store the configuration file.
ScriptManual Specifies the operation that you want to perform—upload,
download, or other.
Applications Specifies the application.
ScriptOperStatus
Specifies the script operation status.
ScriptLastStatusChange Specifies the time of the last status change as sysUpTime.
Retrieving an ASCII configuration file using EDM
Use the
following procedure to retrieve an ASCII configuration file from a TFTP server or from
a USB storage device, and apply it to the switch.
Important:
When you use the TFTP address parameter to perform copy or download commands, the
system overwrites the TFTP server address
System configuration using Enterprise Device Manager
244 Configuration — System April 2011
To Next Page
Loading...
