Avaya 4526FX - Lldp Tx-Tlv Med Command

Table 79: lldp tx-tlv dot3 command variables
Variables Description
port <portlist> The ports affected by the command.
link-aggregation The link aggregation TLV.
mac-phy-config-status The MAC/Phy configuration or status TLV.
maximum-frame-size Maximum Frame Size TLV.
mdi-power-support
The power via MDI TLV. This TLV is enabled by
default.
lldp tx-tlv med command
The lldp tx-tlv
med command sets the optional organizationally specific TLVs for use by
MED devices to be included in the transmitted LLDPDUs. The syntax for the lldp tx-tlv
med command is:
lldp tx-tlv [port <portlist>] med [med-capabilities] [extendedPSE]
[inventory] [location] [network-policy]
The lldp tx-tlv med command is in the config-if command mode.
The following table lists the variables for the lldp tx-tlv med command.
Table 80: lldp tx-tlv med command variables
Variables Description
port <portlist> specifies the ports affected by the command
med-capabilities MED Capabilities TLV (MED TLVs are
transmitted only if MED Capabilities TLVs
are transmitted). This TLV is enabled by
default.
extendedPSE Extended PSE TLV This TLV is enabled by
default.
inventory Inventory TLVs This TLV is enabled by
default.
location Location Identification TLV This TLV is
enabled by default.
network-policy Network Policy TLV This TLV is enabled by
default.
Configuring LLDP using ACLI
Configuration — System April 2011 169