Avaya 4526FX - Default Lldp Tx-Tlv Dot1 Command

Table 84: default lldp tx-tlv command variables
Variables Description
port <portlist> The ports affected by the command.
port-desc
The port description TLV. This TLV is enabled by
default.
sys-name
The system name TLV. This TLV is enabled by
default.
sys-desc
The system description TLV. This TLV is enabled by
default.
sys-cap
The system capabilities TLV (default value is false: not
included).
local-mgmt-addr
The local management address TLV. This TLV is
enabled by default.
default lldp tx-tlv dot1 command
The default lldp
tx-tlv dot1 command sets the optional IEEE 802.1 organizationally-
specifc TLVs to their default values. The syntax for the default lldp tx-tlv dot1
command is
default lldp tx-tlv [port <portlist>] dot1 [port-vlan-id] [vlan-
name ] [port-protocol-vlan-id] [protocol-identity [EAP] [LLDP]
[STP] ]
Run the default lldp tx-tlv dot1 command in Interface Configuration command
mode.
The following table describes the variables for the default lldp tx-tlv dot1
command.
Table 85: default lldp tx-tlv dot1 command variables
Variables Description
port <portlist> The ports affected by the command.
port-vlan-id
The port VLAN ID TLV (default value is false: not
included).
vlan-name The VLAN Name TLV (default value is none).
port-protocol-vlan-id
The port and protocol VLAN ID TLV (default value is
none).
protocol-identity [EAP] [LLDP]
[STP]
The protocol identity TLV (default value is none).
System configuration using ACLI
172 Configuration — System April 2011