5. In the TimeZoneAcronym dialog box, type a time zone acronym.
6. Click Apply.
Variable definitions
The following table describes the T
ime Zone screen fields.
Variable Value
TimeZone Specifies the time zone of the switch, measured as an offset
in 15-minute increments from Greenwich Mean T
ime
(GMT).
TimeZoneAcronym Specifies the time zone acronym.
Configuring daylight savings time using EDM
Use this procedure to configure the start and end of the daylight saving time period.
Prerequisites
Disable the summer time recurring feature.
Procedure steps
1. From the navigation tree, double-click
Edit.
2. In the Edit tree, double-click SNTP/Clock.
3. In the work area, click the Daylight Saving Time tab.
4. In the Offset dialog box, type a value.
5. In the TimeZoneAcronym dialog box, type the time zone acronym.
6. In the StartYear dialog box, type a value.
7. In the StartMonth box, select a month.
8. In the StartDay dialog box, type a value.
9. In the StartHour box, select an hour.
10. In the StartMinutes dialog box, type a value.
System configuration using Enterprise Device Manager
278 Configuration — System April 2011
To Next Page
Loading...
