Variable definitions
Use the
data in this table to configure to configure a list of IPv4 source addresses for which to
permit access to the switch.
Variable Value
Allowed Source IP Address Specifies the source IPv4 address to permit
remote access to the switch.
Allowed Source Mask Specifies subnet mask associated with the
source IPv4 address to permit remote
access to the switch.
Configuring the IPv6 remote access list using EDM
Use this procedure to configure a list of IPv6 source addresses for which to permit remote
access to a switch.
Procedure steps
1. From the navigation tree, double-click Administration.
2.
In the Administration tree, double-click Remote Access .
3. In the work area, click the Allowed List(IPv6) tab.
4. To select a source to edit, click the source row.
5. In the source row, double-click the cell in the Allowed Source IPv6 Address
column.
6. In the dialog box, type a value.
7. In the source row, double-click the cell in the Allowed Prefix Length column.
8. In the dialog box, type a value.
9. Click Apply .
Variable definitions
Use the
data in this table to configure to configure a list of IPv6 source addresses for which to
permit access to the switch .
System configuration using Enterprise Device Manager
214 Configuration — System April 2011
To Next Page
Loading...
