Table 3: show stack auto-unit-replacement fields
Field Definition
Auto Unit Replacement Auto-Restore Enable: During a unit replacement, the
configuration will be automatically restored to
the new unit.
Disable: During a unit replacement, the
configuration will not be restored
automatically
.
Auto Unit Replacement
Auto-Save Enable: The current configuration of a unit in
stack including base unit (if the stack is of 3 units
or bigger) will be automatically saved to the
base unit.
Disable: The current configuration of a unit in
stack including base unit (if the stack is of 3 units
or bigger) will not be automatically saved to the
base unit.
Last Configuration-Save Time-Stamp The system-up time of the non base unit
recorded when the non base unit sends
configuration to the base unit.
Ready for Replacement Yes: The current configuration of the non base
unit is saved to the base unit. This unit is
currently ready for replacement.
No: The current configuration of the non base
unit is not saved to the base unit. The latest
changes of the configuration of the non base
unit will be lost if the unit is replaced with a new
unit.
For information about configuring AUR with ACLI, see Configuring AUR on page
105. For
information about configuring
AUR with Enterprise Device Manager (EDM), see
Configuring
AUR using EDM on page 226
.
AUR function
The CFG
mirror image is a duplicate CFG image (stored in the flash drive) of a unit in a stack.
The mirror image does not reside in the same unit with the CFG image. The unit that contains
Auto Unit Replacement
Configuration — System April 2011 19
To Next Page
Loading...
