Agent Auto Unit Replacement
Use ACLI commands in the following sections to manage and configure AAUR.
You can
currently manage this functionality only through ACLI.
stack auto-unit-replacement-image enable command
Use the stack auto-unit-replacement-image enable command to enable AAUR.
Because AAUR is enabled by default, use this command only if this functionality was previously
disabled.
The syntax for this command is
stack auto-unit-replacement-image enable
Run the stack auto-unit-replacement-image enable command in Global
Configuration command mode.
no stack auto-unit-replacement-image-enable command
Use the no stack auto-unit-replacement-image enable command to disable
AAUR. Because AAUR is enabled by default, you must run this command if you do not want
AAUR functionality on a switch.
The syntax for this command is
no stack auto-unit-replacement-image enable
The no stack auto-unit-replacement-image enable command is executed in the
Global Configuration command mode.
default stack auto-unit-replacement-image enable command
Use the default stack auto-unit-replacement-image enable command to set the
AAUR functionality to the factory default of enabled.
The syntax of this command is
default stack auto-unit-replacement-image enable
Run the default stack auto-unit-replacement-image enable command in Global
Configuration command mode.
System configuration using ACLI
108 Configuration — System April 2011
To Next Page
Loading...
