Avaya 4526FX - Setting up a Terminal

Prerequisites
Log on to the Privileged EXEC mode in ACLI.
Procedure steps
Enter the following command:
show usb-host-port [unit <1-8>]
T
able 31: show usb-host-port parameters
Variable Description
unit <1-8> Specifies a specific switch unit within a stack. Values
range from 1 to 8.
Setting up a terminal
You can customize switch terminal settings to suit the preferences of a switch administrator.
Y
ou must perform this operation in the Command Line Interface.
The terminal command configures terminal settings. These settings include terminal length
and terminal width.
The syntax of the terminal command is:
terminal length <0-132> width <1-132>
Run the terminal command in User EXEC command mode. The following table describes the
for the terminal command.
Table 32: terminal parameters
Variable Description
length Set the length of the terminal display in lines; the
default is 23.
Important:
If
you
set the terminal length to 0, the pagination is
disabled and the display scrolls continuously.
width Set the width of the terminal display in characters; the
default is 79.
System configuration using ACLI
96 Configuration — System April 2011