Avaya 4526FX - Configuring LLDP Using ACLI; Lldp Command

I 00:02:39:52 23 #0 Session closed (console cable disconnected),
serial connection, access mode: no security
Important:
When loading an ASCII configuration file on switch, removing the console cable does not
involve a logout event.
Configuring LLDP using ACLI
You can enable and configure LLDP
using ACLI. For more information about LLDP, see
Link
Layer Discovery Protocol (IEEE 802.1AB) Overview on page 63. This section covers the
following commands:
• lldp command on page 164
• lldp port command on page 165
• lldp tx-tlv command on page 167
• lldp tx-tlv dot1 command on page 168
• lldp tx-tlv dot3 command on page 168
• show lldp command on page 176
• default lldp command on page 170
• default lldp port command on page 170
• default lldp tx-tlv command on page 171
• default lldp tx-tlv dot1 command on page 172
• default lldp tx-tlv dot3 command on page 173
• no lldp port command on page 174
• no lldp tx-tlv command on page 175
• no lldp tx-tlv dot1 command on page 175
• no lldp tx-tlv dot3 command on page 176
• show lldp port command on page 178
• LLDP configuration example on page 192
lldp command
The lldp command sets the LLDP transmission parameters.
The syntax for the lldp
command is
System configuration using ACLI
164 Configuration — System April 2011