Avaya 4526FX - No Lldp Tx-Tlv Dot3 Command; Show Lldp Command

no lldp tx-tlv [port <portlist>] dot1 [port-vlan-id] [vlan-name]
[port-protocol-vlan-id] [protocol-identity [EAP] [LLDP] [STP] ]
Run the no lldp tx-tlv dot1 command in Interface Configuration command mode.
no lldp tx-tlv dot3 command
The no lldp
tx-tlv dot3 command specifies the optional IEEE 802.3 TLVs not to include
in the transmitted LLDPDUs. The syntax for the no lldp tx-tlv dot3 command is
no lldp tx-tlv [port <portlist>] dot3 [mac-phy-config-status] [mdi-
power-support] [link-aggregation][maximum-frame-size]
Run the no lldp tx-tlv dot3 command in Interface Configuration command mode.
show lldp command
The show lldp command displays the LLDP
parameters. The syntax for the show lldp
command is
show lldp [local-sys-data {dot1 | dot3 | detail | med }] [mgmt-sys-
data] [rx-stats] [tx-stats] [stats] [pdu-tlv-size] [tx-tlv {dot1 |
dot3 | med }] [neighbor { dot1 [vlan-names | protocol-id] } | [dot3]
| [detail] | med [capabilities | extended-power | inventory |
location | network-policy]} [neighbor-mgmt-addr]
Run the show lldp command in Privileged EXEC command mode.
The following table describes the show lldp command variables.
Table 90: show lldp command variables
Variables Description
local-sys-data {dot1 | dot3 |
detail | med}
The organizationally-specific TLV properties on the local
switch:
•
dot1: displays the 802.1
TLV properties
• dot3: displays the 802.3 TLV properties
• detail: displays all organizationally specific TLV
properties
• med: displays all med specific TLV properties
To display the properties of the optional management
TLVs, include only the local-sys-data parameter in the
command.
mgmt-sys-data The local management system data.
System configuration using ACLI
176 Configuration — System April 2011