Variable Value
FastStartRepeatCount Indicates the number of times the fast start LLDPDU
is sent during the activation of the fast start
mechanism defined by LLDP-MED.
Configuring port LLPD using EDM
Use the following procedure to configure the optional TL
Vs to include in the LLPDUs
transmitted by each port.
Procedure steps
1. From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click LLDP.
5. On the work area, click the Port tab.
6. To configure LLDP for a port, double-click a cell in a port row under a column
heading.
7. Click Apply .
Variable definitions
The following table describes the Port tab fields.
Variable Value
PortNum Indicates the port number. This is a read-only cell.
AdminStatus Indicates the administratively desired status of the local LLDP
agent:
• txOnly: the LLDP
agent transmits LLDP frames on this port and
does not store any information about the remote systems to which
it is connected.
• rxOnly: the LLDP agent receives but does not transmit LLDP
frames on this port.
• txAndRx: the LLDP agent transmits and receives LLDP frames
on this port.
• disabled: the LLDP agent does not transmit or receive LLDP
frames on this port. If the port receives remote systems
LLDP configuration using EDM
Configuration — System April 2011 287
To Next Page
Loading...
