Variable Value
information which is stored in other tables before AdminStatus is
disabled, the information ages out.
NotificationEnable Controls, on a per-port basis, whether notifications from the agent
are enabled.
• true: indicates that notifications are enabled
•
false: indicates that notifications are disabled.
TLVsTxEnable Sets the optional Management TLVs to be included in the
transmitted LLDPDUs:
• portDesc: Port Description TLV
• sysName: System Name TLV
• sysDesc: System Description TLV
• sysCap: System Capabilities TLV
Note: The Local Management tab controls Management Address
TLV transmission.
VLANTxEnable(dot1) Specifies whether the IEEE 802.1 organizationally defined port
VLAN TLV transmission is included in the transmitted LLDPDUs.
TLVsTxEnable(dot3) Sets the optional IEEE 802.3 organizationally defined TLVs to be
included in the transmitted LLDPDUs:
• macPhyConfigStatus: MAC/PHY configuration/status TLV
• powerViaMDI: Power over MDI TLV
• linkAggregation: Link Aggregation TLV
• maxFrameSize: Maximum-frame-size TLV.
CapSupported(med) Identifies which MED system capabilities are supported on the local
system. This is a read-only cell.
TLVsTxEnable(med) Sets the optional organizationally defined TLVs for MED devices to
include in the transmitted LLDPDUs.
• capabilities: Capabilities TLVs
• networkPolicy: Network Policy TLVs
• location: Emergency Communications System Location TLVs
• extendedPSE: Extended PoE TLVs with PSE capabilities
• inventory: Hardware Revision, Firmware Revision, Software
Revision, Serial Number, Manufacturer Name, Model Name, and
Asset ID TLVs.
The TLVs listed above are enabled by default.
NotifyEnable(med) Enables or disables the topology change traps on this port.
System configuration using Enterprise Device Manager
288 Configuration — System April 2011
To Next Page
Loading...
