Variable definitions
Use the information in the following table to help you understand the base unit information
display.
Variable Value
Type Indicates the switch type.
Descr Describes the switch hardware, including number of ports
and transmission speed.
Ver Indicates the switch hardware version number.
SerNum Indicates the switch serial number.
LstChng Indicates the value of sysUpTime at the time the interface
entered its current operational state. If you entered the
current state prior to the last reinitialization of the local
network management subsystem, the value is zero.
AdminState Specifies the administrative state of the base unit switch.
Values include enable or reset.
Important:
In a stack configuration, the reset command resets
only the base unit.
OperState Indicates the operational state of the switch.
Location Specifies the physical location of the switch.
RelPos Indicates the relative position of the switch.
BaseNumPorts Indicates the number of base ports of the switch.
TotalNumPorts Indicates the number of ports of the switch.
IpAddress Indicates the base unit IP address.
RunningSoftwareVer Indicates the version of the running software.
Renumbering stack switch units using EDM
Use this procedure to change the unit numbers of switches in a stack.
System configuration using Enterprise Device Manager
228 Configuration — System April 2011
To Next Page
Loading...
