Disabling IPv6 interface
Use the following procedure to disable the IPv6 interface:
Enter the following command to disable IPv6.
no ipv6 interface [address <ipv6_address>] [all] [enable]
Displaying the global IPv6 configuration
Use the following procedure to display the IPv6 global configuration:
Enter the following command to display the global IPv6 configuration.
show ipv6 global
Job aid
The following graphic shows a possible result of the show ipv6 global command.
4526(config)#show ipv6 global
forwarding : disabled
default-hop-cnt : 30
number-of-interfaces : 1
admin-status : enabled
icmp-error-interal : 1000
icmp-error quota : 50
icmp-redirect-msg : disabled
icmp-unreach-msg : disabled
multicast-admin-status : disabled
The following table describes the default settings for the fields in the graphic.
Field Default setting
forwarding disabled
default-hop-cnt 30
number-of-interfaces 1
admin-status enabled
System configuration using ACLI
120 Configuration — System April 2011
To Next Page
Loading...
