Variable Value
prevents it from going to the up state. The testing state indicates
that no operational packets can be passed.
LastChange The value of sysUpTime at the time the interface entered its
current operational state. If the current state was entered prior
to the last reinitialization of the local network management
subsystem, the value is zero.
LinkTrap Specifies whether linkUp/linkDown traps should be generated
for this interface.
AutoNegotiate Indicates whether this port is enabled for autonegotiation or
not.
Important:
10/100BASE-TX ports can not autonegotiate correctly with
older 10/100BASE-TX equipment. In some cases, the older
devices can be upgraded with new firmware or driver
revisions. If an upgrade does not allow autonegotiation to
correctly identify the link speed and duplex settings, you can
manually configure the settings for the link in question.
AdminDuplex The current administrative duplex mode of the port (half or
full).
OperDuplex The current mode of the port (half duplex or full duplex).
AdminSpeed Set the port's speed.
OperSpeed The current operating speed of the port.
AutoNegotiationCapabilit
y
Specifies the port speed and duplex capabilities that a switch
can support on a port, and that can be advertised by the port
using auto-negotiation.
AutoNegotiation
Advertisments
Specifies the port speed and duplex abilities to be advertised
during link negotiation.
MltId The MultiLink Trunk to which the port is assigned (if any).
IsPortShared Specifies whether a port is shared. Multiple ports that are
logically represented as a single port are shared. Only one
shared port can be active at a time.
PortActiveComponent Specifies the physical port components that are active for a
shared port.
Changing the configuration for specific interface ports using EDM
Use this procedure to modify configuration parameters for one or more interface ports.
Interface port management using EDM
Configuration — System April 2011 231
To Next Page
Loading...
