Displaying the IPv6 address for a switch or stack
Use the following procedure to display the IPv6 address for a switch or stack:
show ipv6 address
Enter the following command:
show ipv6 address
show ipv6 address interface
Enter the following command to display all or a specific ipv6 interface address.
show ipv6 address interface <ipv6_address>
Job aid
The following graphic shows the results of theshow ipv6 address interface
command.
4526(config)#show ipv6 address interface
=======================================================================================
Address Information
=======================================================================================
IPV6 ADDRESS VID/BID/
TID
TYPE ORIGIN STATUS
-------------------------------------------------------------------------------------------------------------------------------------------------
3000:0:0:0:0:0:0:99 V-1 UNICAST MANUAL PREFERRED
fe80:0:0:0:211:f9ff:fe34:8800 V-1 UNICAST OTHER UNKNOWN
2out of 2Total Num of Address Entries displayed.
Configuring IPv6 interface properties
Use the following procedure to configure the IPv6 interface, create the VLAN IPv6 interface,
and set the parameters
Enter the following command:
System configuration using ACLI
118 Configuration — System April 2011
To Next Page
Loading...
