Important:
To remove all three server addresses, you must enter the command three times, each with
a different server address.
Table 73: no ip name-server parameters on page 163 outlines the parameters for this
command.
Table 73: no ip name-server parameters
Parameter Description
<ip_address_1> The IP address of the domain name server to
remove.
<ip_address_2> Optional. The IP address of a domain name server to
remove from the list of servers used by the switch.
<ip_address_3> Optional. The IP address of a domain name server to
remove from the list of servers used by the switch.
Run this command in Global Configuration command mode.
Serial Security
This feature involves logout event when serial console is pulled out.
The commands for serial security are:
4548GT-PWR(config)#serial-security enable
- Enable serial security
4548GT-PWR(config)#no serial-security enable
- Disable serial security
4548GT-PWR(config)#default serial-security enable
Important:
By default this feature is disabled, the show serial-security command displays the
status of the serial security.
Following is an example for show serial-security
command:
4548GT-PWR#show serial-security
Serial security is disabled
The following message should be logged during the logout event:
General switch administration using ACLI
Configuration — System April 2011 163
To Next Page
Loading...
