Avaya 4526FX - Storing Configuration in Binary File

show script status command
Use the show script status command to view the status of one or all the entries.
The
syntax for the show script status command is:
show script status [<1-127>]
The show script status command is executed in the Privileged EXEC command
mode.
Table 20: show script status parameters on page 87 outlines the parameters for this
command.
Table 20: show script status parameters
Parameters Description
<1-127> The index of the entry to be used.
Storing configuration in binary file
For all switches in the Avaya Ethernet Routing Switch 4500 Series, you can store the
configuration file to a TFTP server and a USB Mass Storage Device through the front panel
USB drive. You can store the current configuration into binary configuration file types. You can
store the configuration in binary files using the copy config {tftp | usb} command. For
more information, see the following sections:
• copy config tftp command on page 87
• copy config usb command on page 88
copy config tftp command
Use the copy
config tftp command to store configuration in a binary file to a TFTP server.
The syntax for the copy config tftp command is:
copy config tftp {address <A.B.C.D>| filename <filename>}
Important:
When you use the TFTP address parameter to perform copy or download commands, the
system overwrites the TFTP server address.
The copy config tftp command is executed in the Privileged EXEC command mode.
The following table outlines the parameters for the copy config tftp command.
Configuration files in ACLI
Configuration — System April 2011 87