lldp [tx-interval <5-32768>] [tx-hold-multiplier <2-10>] [reinit-
delay <1-10>] [tx-delay <1-8192>] [notification-interval <5-3600>]
[med-fast-start <1-10>]
Run the lldp command in Global Configuration command mode.
The following table describes the variables for the lldp command.
T
able 74: lldp command variables
Variables Description
tx-interval <5-32768>
Set the interval between successive
transmission cycles.
tx-hold-multiplier <2-10>
Set the multiplier for the tx-interval used to
compute the T
ime To Live value for the TTL
TLV.
reinit-delay <1-10>
Set the delay for the reinitialization attempt if
the adminStatus is disabled.
tx-delay <1-8192>
Set the minimum delay between successive
LLDP frame transmissions.
med-fast-start <1-10> Set value for med-fast-start.
notification-interval <5-3600>
Set the interval between successive
transmissions of LLDP notifications.
lldp port command
The lldp port command sets the LLDP
port parameters. The syntax for the lldp port
command is
lldp port <portlist> [config notification] [status {rxOnly | txAndRx
| txOnly}]
Run the lldp port command in Interface Configuration command mode.
The following table describes the variables for the lldp port command.
Table 75: lldp port command variables
Variables Description
port <portlist> Specify the ports affected by the command.
config notification
Enable notification when new neighbor information is
stored or when existing information is removed. The
default value is enabled.
Configuring LLDP using ACLI
Configuration — System April 2011 165
To Next Page
Loading...
