Clearing the default TFTP server
You
can clear the default TFTP server from the switch and reset it to 0.0.0.0 with the following
two commands:
•
no tftp-server
This command has no parameters and you run it in Global Configuration command
mode.
•
default tftp-server
This command has no parameters and you run it in Global Configuration command
mode.
Configuration files in ACLI
ACLI provides many options for working with configuration files. Through
ACLI, you can
display, store, and retrieve configuration files.
For details, see the following sections:
•
Displaying the current configuration on page 77
• Storing the current configuration in ASCII file on page 84
• Storing configuration in binary file on page 87
• Restoring configuration from an ASCII file on page 88
• Restoring configuration from a binary file on page 91
• Saving the current configuration on page 92
• Viewing USB files on page 94
• Viewing USB host port information on page 95
Displaying the current configuration
To display the current configuration of switch or a stack, use the show running-config
command,
with the following syntax, in Privileged EXEC command mode with no parameters:
The syntax of this command is:
show running-config [verbose] [module <value>]
You can enter [module <value>] parameters individually or in combinations.
Configuration files in ACLI
Configuration — System April 2011 77
To Next Page
Loading...
