3. In the work area, select the License File tab.
4. In the TftpServerInetAddressType section, click a radio button.
5. In the TftpServerInetAddress dialog box, type the TFTP server IP address.
6. In the LicenseFileName dialog box, enter the software license filename on the TFTP
server.
Important:
The LicenseFileName dialog box is case sensitive and you can use a maximum
of 64 characters including the file extension. Numerals are allowed in the
LicenseFileName dialog box, but special characters like @, -, #, are not
allowed.
7. In the UsbTargetUnit dialog box, type a value.
8. In the LicenseFileAction section, click the dnldLicense radio button.
9. In the Remove License section, select a value from the list, to remove one or all
licenses.
10. Click Apply.
When the file installation is complete, a warning message appears prompting you
to restart the switch to activate the license.
For information about restarting the switch, see Configuring system parameters
using EDM on page 220.
Saving the current configuration using EDM
The configuration currently in use on a switch is regularly saved to the flash memory
automatically.
However, you can manually initiate this process using the Save Configuration
tab.
Use the following procedure to save the current configuration manually.
Procedure steps
1. From the navigation tree, double-click Edit
.
2. In the Edit tree, double-click File System.
3. On the work area, click the Save Configuration tab.
4. Select the AutosaveToNvramEnabled check box to enable automatically saving
the configuration to the flash memory.
Saving the current configuration using EDM
Configuration — System April 2011 247
To Next Page
Loading...
