show lldp med-network-policies [port <portList>] {voice|voice-
signaling}
Run the show lldp med-network-policies command in Privileged EXEC command
mode.
The following table describes the variables for the show lldp med-network-policies
command.
T
able 92: show lldp med-network-policies command variables
Variable Value
port <portlist>
Specifies the port or ports for which to display LLDP
MED policy information.
voice
Displays the voice network policy for which to display
information. The default value is 46.
voice-signaling
Specifies the voice signalling network policy to
disable.
Note:
The default DSCP value is 46 and the default priority value is 6.
Configuring the PoE conservation level request TLV using ACLI
Use this procedure to request a specific power conservation level for an A
vaya IP phone
connected to a switch port.
Prerequisites
Log on to the Interface Configuration mode in ACLI.
Procedure steps
1. Configure PoE conservation level TLVs for connected Avaya IP phones by using
the following command:
lldp [port <portList>] vendor-specific avaya poe-
conservation-request-level <0-255>
2. Set PoE conservation level TLVs for connected Avaya IP phones to the default value
by using the following command:
default [port <portList>] lldp vendor-specific avaya poe-
conservation-request-level
System configuration using ACLI
180 Configuration — System April 2011
To Next Page
Loading...
