show stack auto-unit-replacement-image command
Use the show stack auto-unit-replacement-image command to view the current
status of the AAUR functionality
.
The syntax of this command is
show stack auto-unit-replacement-image
Run the show stack auto-unit-replacement-image command in User EXEC
command mode.
Configuring DAUR
There are no commands to separately enable or disable DAUR.
Setting Stack Forced Mode
This section describes the procedures and commands to configure Stack Forced Mode on a
two unit stack.
Use ACLI Global Configuration command mode to configure Stack Forced Mode.
This section contains the procedures to configure stack forced-mode.
Configuring stack forced-mode
Use the following procedure to configure stack forced-mode:
1. Enter
<no | default | show> stack forced-mode.
2. Press Enter.
Job aid
The following table defines the options for the stack forced-mode command.
Table 39: Options for stack forced-mode
Option Definition
<> Enable Stack Forced Mode.
Setting Stack Forced Mode
Configuration — System April 2011 109
To Next Page
Loading...
