Avaya 4526FX - Restoring Configuration from a Binary File

The script run command is executed in the Privileged EXEC command mode.
Table 26: script run command parameters on page 91 outlines the parameters for this
command.
Table 26: script run command parameters
Parameters Description
<1-127> The index of the ASCII configuration script
table entry to be used.
<A.B.C.D> The IP address of the tftp server to load the
script.
<filename> The name of the file to be restored.
<1-8> The unit number in which the USB device is
inserted in, if the unit is a part of the stack.
Restoring configuration from a binary file
You can restore the configuration from a binary file using the following commands:
•
copy tftp config command on page 91
• copy usb config command on page 92
copy tftp config command
Use
the copy tftp config to restore a configuration from a binary file from a TFTP server.
You can also use this command to copy the configuration of a switch in a stack to a stand-
alone switch and to replace units in the stack.
Important:
When you use the TFTP
address parameter to perform copy or download commands, the
system overwrites the TFTP server address.
The syntax for the copy tftp config file is:
copy tftp config address <XXX.XXX.XXX.XXX> filename <name> unit <unit
number>
The copy tftp config command is executed in Privileged EXEC command mode.
Table 27: copy tftp config parameters on page 92 outlines the parameters for this
command.
Configuration files in ACLI
Configuration — System April 2011 91