Procedure steps
1. From the Device Physical V
iew, click a port.
2. From the navigation tree, double-click Graph.
3. In the Graph tree, double-click Port .
4. In the work area, click the Bridge tab.
5. On the toolbar, select a value from the Poll Interval list.
6. To reset the statistics counters, click Clear Counters.
7. To select bridge statistical information to graph, click a data row under a column
heading.
8. On the toolbar, click Line Chart, Area Chart, Bar Chart, or Pie Chartcolumn.
Variable definitions
Use the data in the following table to help you understand port bridge statistics.
Variable Value
DelayExceededDiscards Number of frames discarded by the port due to excessive
transit delays through the bridge. It is incremented by both
transparent and source route bridges.
MtuExceededDiscards Number of frames discarded by the port due to an excessive
size. It is incremented by both transparent and source route
bridges.
InFrames The number of frames that have been received by this port
from its segment.
OutFrames The number of frames that have been received by this port
from its segment.
InDiscards Count of valid frames received which were discarded (filtered)
by the Forwarding Process.
Configuring SNTP using EDM
Use the following procedure to configure Simple Network T
ime Protocol (SNTP).
Configuring SNTP using EDM
Configuration — System April 2011 275
To Next Page
Loading...
