show poe-port-status [<portlist>]
Substitute <portlist> with the ports for which to display configuration.
Run the show poe-port-status command in Global Configuration command mode.
Show port power measurement
The show port power measurement command displays the power configuration.
The syntax for the show port power measurement command is:
show poe-power-measurement [<portlist>]
Substitute <portlist> with the ports for which to display configuration.
Run the show poe-power-measurement command in Global Configuration command
mode.
General switch administration using ACLI
This section
describes the ACLI commands used in general switch administration. This section
contains the following topics:
•
Multiple switch configurations on page 130
• Configuring system IP addresses and boot mode on page 131
• Assigning and clearing IP addresses for specific units on page 137
• Displaying Interfaces on page 138
• Displaying configuration information for ports on page 139
• Setting port speed on page 140
• Initiating a cable diagnostic test using ACLI on page 143
• Enabling Autotopology on page 144
• Enabling flow control on page 145
• Enabling rate-limiting on page 147
• Using Simple Network Time Protocol on page 150
• Configuring local time zone on page 154
• Configuring daylight savings time on page 154
• Clock configuration on page 157
• Custom Autonegotiation Advertisements on page 157
General switch administration using ACLI
Configuration — System April 2011 129
To Next Page
Loading...
