Avaya 4526FX - No Stack Auto-Unit-Replacement Enable Command; Default Stack Auto-Unit-Replacement Enable Command; Stack Auto-Unit-Replacement Config Save Enable

Run the stack auto-unit-replacement enable command in Global Configuration
mode.
No parameters or variables are available for the stack auto-unit-replacement enable
command.
no stack auto-unit-replacement enable command
The no stack auto-unit-replacement enable command disables AUR on the
switch.
The syntax for this command is
no stack auto-unit-replacement enable
Run
the no stack auto-unit-replacement enable command in Global Configuration
mode.
No parameters or variables are available for the no stack auto-unit-replacement
enable command.
default stack auto-unit-replacement enable command
The default stack auto-unit-replacement enable command restores the default
AUR settings.
The syntax for this command is
default stack auto-unit-replacement enable
Run the default stack auto-unit-replacement enable command in Global
Configuration mode.
No parameters or variables are available for the default stack auto-unit-
replacement enable command.
stack auto-unit-replacement config save enable
The stack auto-unit-replacement config save enable command enables
automatic configuration saves for non-base units.
No parameters
or variables are available for the stack auto-unit-replacement config
save enable command.
System configuration using ACLI
106 Configuration — System April 2011